Jump to content

User Area

Username

Password

or

Sponsors


Who's Online

Membership:

 Latest: avj
 New Today: 0
 New Yesterday: 1
 Overall: 23114

People Online:

 Members: 0
 Visitors: 36
 Total: 36

Online Now:



Tm Vsr-10 Upgrade Guide

  • Please log in to reply
1 reply to this topic

#1 Lacross

Lacross
  • Corporal
  • 27 posts

Posted 30 August 2010 - 10:04 AM

This Guide Will Help You Pick Out Parts to Upgrade Your Marui VSR

This guide was taken from "Dusk" a member on "Airsoft Retreat"

All the parts listed below are "laylax" parts.

-360fps-
Needed:
*ps110 spring

Recommended:
*Trigger Sear
*Piston Sear
*Spring Guide


-392fps-
Needed:
*ps120 spring
*Trigger Sear

Recommended:
*Piston Sear
*Spring Guide Stopper
*Spring Guide
*High Pressure Piston


-427fps-
Needed:
*ps130 spring
*Trigger Sear
*Piston Sear

Recommended:
*Spring Guide
*Spring Guide Stopper
*High Pressure Piston
*Silent Damper Piston Head


-492fps-
Needed:
*ps150 spring
*Trigger Sear
*Piston Sear
*High Pressure Piston
*Spring Guide

Recommended:
*Silent Damper Piston Head
*Zero Trigger

-558fps-
Needed:
*ps170 Spring
*Trigger Sear
*Piston Sear
*Spring Guide
*Spring Guide Stopper
*High Pressure piston
*Silent Damper Piston Head

Recommended:
*Zero Trigger System
*Teflon Cylinder


Notes:
1.Before you buy your vsr-10, please note, to do these mods, you must remove a stainless steel pin to get into the cylinder.Otherwise, you must buy a laylax teflon cylinder,piston, spring, and spring guide to upgrade if you cant remove the pin.
2.If you suffer from accuracy, and fps problems, check this out.
-First, remove your cylinder
-Second, look inside, if you see a little grey dot on the bottom of the reciever, dont worry about this part.If theres a hole,heres what you do. First, take out the set screw on the bottom of the reciever.Second, With the bottom of the reciever facing you, turn the outer barrel away from you untill the the hole in the barrel, and the reciever line up. Put the set screw back it.

Check your hop up if it wiggles or not. If it does, take a philips head screwdriver and tighten it.
Good now your done!
3.How do you take of your cylinder head you ask?(after pin has been removed) First, put electrical tape/duct tape around the nozzel, then use a pair of needle nose plyers to remove it.

ps...... i take no credit for this whatsoever, its Dusks upgrade guide just posting it on the new forums since i couldnt find it forever

#2 Lacross

Lacross
  • Corporal
  • 27 posts

Posted 30 August 2010 - 10:08 AM

If you have other questions about a vsr-10 please pm me.


1 user(s) are reading this topic

0 members, 1 guests, 0 anonymous users